Skip to content

#3dPrinting: Bracket for Xiaomi MI Vacuum Cleaner Mini

A pre-production model
As some of you know, I hate nothing more than housework. Therefore, everything that is possible is automated here. For example vacuum cleaning. A Roborock S5Max is working on the floors in our lumber room, but what about the crumbs from the cake on the tablecloth? This is the job of the recently released MI Vacuum Mini Cleaner, an accu-powered mini cyclone vacuum cleaner that does its job well, but unfortunately comes without a wall bracket.

So I just broke a simple and hopefully functional design from the fence, which is based on the same of the Xiaomi designers. I say so now ... ;-)

However, here it is for your convenient use. I printed it with matte white Extrudr PLA NX2, which is beautiful and goes well with the matte finish of the cleaner. However, here it is for your convenient use. I printed it with matte white Extrudr PLA NX2, which is beautiful and goes well with the matte finish of the nipple. You don't need to use supports when printing, or you may have problems removing it from the cable duct in the floor. You can use the part with the two openings on the back that are intended for attaching the holder to the wall with two screws. By the way, the distance between the necessary holes would be 40mm.

Have fun with printing and always good 1st layer adhesion ;-)



I hope the thing is useful for you. Some of the links are suggestions for parts to replicate the thing and affiliate. If you buy something, I get a small commission. The price you pay is the same. Thank you very much.

1st published @ thingiverse

Trackbacks

Keine Trackbacks

Kommentare

Ansicht der Kommentare: Linear | Verschachtelt

Noch keine Kommentare

Kommentar schreiben

Die angegebene E-Mail-Adresse wird nicht dargestellt, sondern nur für eventuelle Benachrichtigungen verwendet.
Um einen Kommentar hinterlassen zu können, erhalten Sie nach dem Kommentieren eine E-Mail mit Aktivierungslink an ihre angegebene Adresse.

Um maschinelle und automatische Übertragung von Spamkommentaren zu verhindern, bitte die Zeichenfolge im dargestellten Bild in der Eingabemaske eintragen. Nur wenn die Zeichenfolge richtig eingegeben wurde, kann der Kommentar angenommen werden. Bitte beachten Sie, dass Ihr Browser Cookies unterstützen muss, um dieses Verfahren anzuwenden.
CAPTCHA

Umschließende Sterne heben ein Wort hervor (*wort*), per _wort_ kann ein Wort unterstrichen werden.
BBCode-Formatierung erlaubt
Formular-Optionen

Kommentare werden erst nach redaktioneller Prüfung freigeschaltet!

cronjob